Skip to content
W-1 · PlanningW-1 build book

W-1 Renders

W-1, rendered from its design files.

Every picture here is built in Blender straight from design.py and the laser files: the bottle shape from the design's placeholder sizes, the fins, rings, bulkheads and spine exactly as cut, 500 ml of water, and the NOVTAR wordmark as a vinyl decal. Bought parts are simple blocks at their real size.

Open the 3D model Rendered from the design files
01W-1Two clear 2 litre bottles, a quarter full of water, four varnished birch fins, the foam tip and the NOVTAR wordmark decal on the payload bottle.
02Side view, to scale610 mm long, 104 mm bottles, fins 180 mm span. Orthographic and shown empty, so the water isn't lying in the bottle.
03CutawayCut down the middle, upright with its 500 ml of water: clay ballast in the neck, the flight computer on the spine, the timer and folded parachute, bulkhead B3 on the pressure bottle's feet, and the fin can on the shoulder.
04ExplodedPayload bottle with its tip and ballast, the payload core, the joint tape, the pressure bottle, and the fin can with its four fins.
05Fin canFour fins half-lapped into three rings exactly as cut in 01_fins and 02_fin_can, sitting on the pressure bottle's shoulder, 45 degrees either side of the hatch. No glue touches the bottle.
06Payload coreBulkheads B1, B2 and B3 on the spine, with the flight computer, its three status LEDs (lit green), battery, sensors and the wind-up timer (bought parts as simple blocks, to size) and the folded parachute.
07On the launcherW-1 on its launcher (rev B): the crossed legs and hub from 04_launcher_stand, the three-layer post holding the lower 15 mm copper pipe in two clips, the brass tee and relief valve just above the hub, and the compression coupler whose top nut is the O-ring seat. The bottle's mouth sits on that seat with the 200 mm launch tube inside it.
08Every laser-cut partAll the cut sheets, part for part as they come off the laser, engraving up.