Skip to content
W-1 · PlanningW-1 build book

W-1 3D model

W-1, part by part, as it will be built.

Every plywood part is drawn from the laser files and both bottles from the design numbers, with the water at a quarter fill. Pull it apart, look inside the payload core, and tap anything to see what it is.

Drawn from the design filesEvery plywood part from the laser files

View

Look

Show

Length
610 mmEST.
Bottles
104 mm
Mass, empty
668 gEST.
Mass, with water
1168 gEST.
Stability, full
1.03 calEST.
W-1Full rocketTap or hover any part.
Drag to orbit · scroll to zoom · tap a part

Where the shapes come from

Every plywood part is rebuilt from the laser files in w1/out/laser. The bottles follow the same outline as the side drawing in w1/design.py; their sizes are placeholders until you measure your bottles, and this model updates when you do.

Nothing is glued to the pressure bottle

The fin can seats on the shoulder and is taped; the payload is held by the base pushing on B3 and a taped sleeve. The bottle is exactly as it came from the shop.

What isn't drawn exactly

The bottles' moulded feet and neck ring, the sensors' places on the spine, and the timer (shown as a box the size of its plate) aren't fixed in the design yet. The fins sit 45° either side of the hatch, as design.py sets. The launcher is in the cut sheets; its pipe height isn't fixed, so it isn't assembled here.