N-1 TVC 3D model
N-1 TVC, part by part, in plywood.
The gimbal, servo bay and test rig exactly as the laser files cut them. Tilt the gimbal with the sliders, pull it apart, cut the booster open, and tap anything to see what it is and why.
View
Look
Show
- Gimbal travel
- 5°
- Motor
- 29 mm
- Tightest gap to tube
- 0.75 mm
- Added mass
- 114 gEST.
- Stability with TVC
- 1.37 calEST.
- Birch plywood, 3 mm, from the laser files
- Laser-burnt edge
- Booster tube, matte black
- Kraft cage tube
- Steel pins and pushrods
- Brass bushings
- Micro servos
Where the shapes come from
Every plywood part is rebuilt from the laser files in tvc/out/laser and placed where tvc/design.py puts it. Pins, bushings, the cage tube, motor, servos, pushrods and electronics are plain shapes at the design's sizes.
What can't be wood
The pivot pins and bushings (they carry the thrust and turn), the pushrods and servos, the electronics, the kraft cage tube round the motor case, and the epoxy. Everything else, including the whole rig, is plywood.
Nothing here is built yet
The tilt sliders show the gimbal's full 5 degree travel. On the real thing the firmware starts in shadow mode and only moves the servos on the rig, with no motor.