Every picture here is built in Blender straight from design.py and the laser files: the real outlines, holes and engraving of every plywood part, the tubes at their real sizes, and the finish we've chosen (matte white nose, matte black body, varnished birch fins, the NOVTAR wordmark as a vinyl decal). Bought parts are simple blocks at their real size.
01N-1The finished rocket: matte white nose, matte black body, varnished birch fins with the mark pointing at the nose, the NOVTAR wordmark reading up the booster, and the three status LED windows, lit green as on a good pad check.
02Side view, to scale800 mm long, 57 mm across. Orthographic, so every length is true to the design.03CutawayCut down the middle: the sanded plywood nose stack, the avionics sled in the coupler, the bulkhead and eye bolt, the folded parachute and Kevlar cord, and the motor mount with its three centring rings and a 29 mm motor.04ExplodedEvery part in assembly order: nose, payload tube, sled and bulkheads, coupler, booster, fins, motor mount and motor clips.05Fin canThree through-the-wall fins exactly as cut in 01_fins.svg, with the engraved mark, on the matte black booster.06Avionics bayThe sled with the flight computer, sensors and battery (bought parts shown as simple blocks, to size; the status LED strip is on the back face), the sled cap, the three bulkhead discs and the M5 eye bolt, pulled apart.07Nose cone stackThe 68 laser-cut rings of the nose on their 8 mm dowel, before sanding to the ogive and painting.08On the display standThe laser-cut stand with the engraved lockup, holding N-1 at its balance point.09Every laser-cut partAll the cut sheets, part for part as they come off the laser, engraving up.