Every picture here is built in Blender straight from kit/design.py and its laser files: the hub, leg cheeks, yoke, rail foot, boxes, reel, table and crate exactly as cut, with N-1 and W-1 from their own design files. Bought parts (rail, legs, blast plate, switches, lights, laptop) are simple solids at their real size.
01N-1 on the padThe folding pad set up: three aluminium legs on swivel feet, the hub and yoke as cut, the 1.2 m 1010 rail at 0 degrees, the steel blast plate and the orange rail cap. N-1 sits on its rail buttons with its aft end 50 mm above the plate. Pad lights green: key out, safe. The launch lead runs off to the controller, 15 m away.
02Pad lights, armedAmber on all three legs: the key is in at the controller. The light bars sit on the outer half of each leg, well below and away from the blast plate, and run off their own battery. They only show what the controller's key and button are doing; they never decide anything.03Launch controllerSafety key, ARMED and CONTINUITY lights, and the launch button inside its laser-cut guard. The firing side (left) and the lights side (right) are split by a divider; only two dry switch contacts cross it. Beside it, the 15 m lead on its reel.04Base stationThe slot-together table with the laptop running Mission Control (a Simulation mode screenshot), the N-1 ground station strapped to the top of the antenna mast, and the crate with the controller and reel. This end stays at least 10 m from the pad.05W-1 on its launcherRev B launcher: the bottle seals 180 mm above the hub on the coupler's O-ring, the cable ties and collar hold its neck, and the post stops 60 mm below the seal so nothing touches the fins. The legs pull out for packing. Hose and pull cord run 10 m back to the operator.06PackedEverything folded: the pad's legs swung down beside the hub, the rail in two halves, W-1's legs and launcher head, and the crate closed with the controller, lights box, reel and table inside. Two things to carry.07Every laser-cut partAll fifteen kit sheets, part for part as they come off the laser, engraving up.