Radio commands only ping or beep. Nothing here can fire anything on the rocket.
Altitude
0m
above the pad
Peak
0m
apogee
Vertical speed
0.0m/s
max 0.0
Acceleration
1.0g
max 0.0
N-1 · 3D live
PhasePAD
Altitude0m
Speed0m/s
Height and phase from telemetry. N-1 doesn't measure its tilt, so it's shown upright.
Altitude live
Replay
10T minus · simulation
Climb
0 m
Vertical speed m/s
Acceleration g
Launch status
NO-GO
Events
Waiting for a connection.
Bench tests build book 07
Do all of these before the first flight, with the rocket's board talking to the ground station. Tests marked auto pass or fail from the telemetry; the rest you tick. Nothing here can fire anything.
01Start-up
Waiting
Switch on: three short beeps, then baro, IMU and logging all OK, flash not full, battery read.
auto
02Stair climb
Waiting
Measure the height of a staircase. Press Start at the bottom, carry the board up, then wait at the top until it passes.
03Shake to BOOST
Waiting
Press Start, then shake the board hard. It should switch to BOOST, then go back to PAD by itself about 10 s later because it never climbed.
04Range test
Waiting
Ground station at one end of an open field. Press Start, walk the rocket's board out to 500 m (pace it or use a map), then press "At 500 m".
05Battery run time
Waiting
Charged battery, board on, this page open. Passes after 1 hour if telemetry never stopped for more than 10 s.
06Download a log
Waiting
Connect over Rocket USB and download a test log. Passes when a rocket log is in the flight library; open it and check the chart looks right.
auto
07Stability
Manual
Swing test, or OpenRocket with the real weighed masses: stability between 1 and 2 calibres.
Flight library · 0 flights
No flights saved yet. Every connected session and every downloaded log appears here.